The AC Voltage Detector indicates an ALARM/NORMAL condition in software and also via an LED mounted on the sensor. Voltage detectors can detect the presence or the absence of line voltage. It is designed for use worldwide. There is an SNMP interface for getting the alarm/normal status. SNMP traps are sent when critical conditions occur. SNMP polling via 'get' is available to retrieve existing status and configuration parameters. The Web browser interface is also available to display the status and configuration parameters.

When an alarm condition is activated the description and location of the fault can be sent via email, page or traps.

• Measurement range - Detects voltage at 50V AC to 250 VAC
• LED indicator on sensor shows if voltage present
• Measurement Indication - Alarm or Normal
• Communications cable - RJ45 jack to sensor using UTP Cat 5 wire.
• Sensor type - open/closed contact switch
• Power source: powered by the sensorProbe. No additional power needed.
• Power Consumption: Typical 11.35 mWatt, 2.27mA
• sensorProbe auto detects the presence of the voltage sensor
• Measurement rate - multiple readings every second
• Up to 2 voltage detector per sensorProbe2, up to 8 on the sensorProbe8.
• Full autosense including disconnect alarm